Highland Brand - Anchor Points
4.6 stars - 5 reviewsmoreBull Ring Retractable Anchor Points mount in your truck's stake pockets. The heavy duty stainless steel eye snaps up for use and snaps down for a smooth profile. Each Bull Ring has a 1000 lb. load capacity and UV-protected black surface plate. Simple No-drill installation. Fits newer fullsize trucks with stake pocket holes, including Chevy, Dodge, GMC, and Ford F-Series (97 and newer). Does not fit Toyota Tundra. Sold in Pairs. Made for Highland by Bull Accessories, these are the same product as Bull Ring # 4001.
- moreThis is a LARGE industrial grade clamp-on anchor point for trucks, vans, or trailers. The anchor point can be used anywhere along the side rail of trailers, truck beds with flanged sidewalls, or other suitable locations. The body is constructed of stamped and welded 8 gauge steel (~0.17 inches/4.4mm thick); it measures 4.5 inches wide by 4.1 inches tall by 2.5 inches in depth. The maximum opening is 2.6 inches with the 0.2 thick rubber pad in place. The clamping bolt is 5/8 inch with a 1.25 inch diameter x 0.5 inch thick checkered surface steel shoe on one end and 7/16 inch square lug for optionally tightening the clamp with a wrench on the other end. The cast steel ring which can be rotated nearly 180 degrees about its horizontal axis has an outer diameter of 2.2 inches and a inner opening of 1.4 inches. The ring cross-section is a nominal 0.4 inches. The ring pivots on a 5/16 bolt with a locking nut. This movable anchor has a working load limit of 1000 pounds. Sold individually.
- moreThis is a pair of heavy duty movable truck or trailer anchor points. These anchor points work on most trailers and truck beds with flanged sidewalls. Easy to use, simply turn the handle clockwise to tighten until secured or counter-clockwise to loosen the anchor point to move it to a different place. The body of the anchor-point is stamped 8 gauge steel with a bright rust resistant coating. The lower portion of the clamp body is rubber coated to prevent scratching painted surfaces.The body of the clamp is 2.5 inches wide and 3.2 inches tall; the max opening is approximately 1.4 inches. The overall height of the body including the tie-down ring is 4.5 inches. The ring opening is approximately 1.25 inches wide and 0.7 inches tall. The clamp screw has wing type jam nut to prevent the clamp from coming loose. The anchor-ring is angled at approximately 60 degrees.
- - -